Voters 2
-
M
-
2
Buttons to increase/decrease SOC in navigation mode do not work
- Done
|
M |
mh |
Buttons to increase/decrease SOC in navigation mode do not work.
Activity Newest / Oldest
Mattias_ABRP
Status changed to: Done
Mattias_ABRP
Status changed to: Investigate
Mattias_ABRP
Status changed to: Done
Mark Krautheim
On further investigation: it *is* working, there's just a 10-20 second delay between the time I press the buttons and the time the value is updated - and sometimes, it jumps a step or two before settling back down.
A concrete example:
- Battery level is shown as `79%`
- I press `+` once
- 8 seconds later, it jumps to `81%`
- 25 seconds after that, it drops back to `80%`
mh
It’s not working for me. It changes +/-1 every few seconds, though. I am sitting at my desk, started a navigation, pressed (-) 10 times, waited for more than a minute. Nothing happened besides the small changes +/-1.
Mattias_ABRP
Hey Mark, which version of the app are you using. This was fixed quite recently and I just tested it and it does work now on the latest version. If there is round burrons the clicking should work with the value increasing on clicking.
mh
I have round button. iOS. Version 4.3.2 (1964). Not working. 😕
As I said, I did the latest tests from my desk, so no GPS position change etc. Could it be associated with that?
Mattias_ABRP
Yes that might be part of the issue. If you could test it while driving it would be great!
Mark Krautheim
4.3.2 (1975), Android V13. I'm testing it right now, in my car with ABRP up and navigating on the car screen. Still highly un-responsive - when I push the buttons on the phone screen, sometimes it updates, sometimes it doesn't, but I always have to wait about 10-30 seconds for something to happen and/or for the number to stop jumping up and down.
mh
It works a bit while driving. It seems it takes a button press every 10 seconds or so. It takes ages and a lot of unsuccessful taps to reach the current number.
Important use case: I start a navigation. I realize the SOC is slightly off. (Maybe I used battery for pre-heating.) I want to fine-tune the SOC before I start driving. That’s not possible, at the moment using these buttons.
Mattias_ABRP
Thanks for testing MH, have now solved this so it 's proper responsive and you can quickly edit the SoC with no issues when driving and not driving. The fix will be in the next release so later this week.
mh
Great! Works here.
Katya_ABRP
Status changed to: In progress
Mark Krautheim
Sorry, still not working for me:
Android 13
Google Pixel 4a(5G)
ABRP Version 4.3.2, Dec 6, 2022
Bo_ABRP
Status changed to: Done
Bo_ABRP
This should have been fixed now, please report back if you don't agree!
Katya_ABRP
Status changed to: Investigate